Gemel Txshs User Manual _top_ Jun 2026

If your remote stops responding (often after a battery change or if buttons were pressed over 256 times out of range), use this procedure to re-pair it:

If you see error code E-401 on the OLED screen, it indicates an activation key mismatch. Re-enter the SN from the bottom panel. Gemel Txshs User Manual

: If you need to transport the bike (e.g., on a trailer or ferry), arm the system by pressing Button 1 , then press it a second time within the activation phase. The indicators will flash three times to confirm the motion sensors are off. Synchronization Procedure If your remote stops responding (often after a

Copyright © 2026 Gemel Technologies. Gemel Txshs is a registered trademark. No part of this user manual may be reproduced without written permission. on a trailer or ferry)