No Sync Signal Jrc Radar Official

| Step | Action | What to look for | |------|--------|------------------| | 1 | Is the antenna rotating? (Visually or via rotation indicator light) | If stopped → Motor/power issue, not just sync. | | 2 | Check radar mode: Transmit (TX) selected? | Some units show “NO SYNC” when in STBY or if magnetron heater is off. | | 3 | Cycle power (radar processor and scanner) | Temporary glitches in signal detection. | | 4 | Check heading source (Gyro/GNSS) if interfaced | Some JRC radars reject sync if heading data is invalid. |

: A failure in the radar interface circuit or the signal processing board (often the "TRX" or "Control" board). Troubleshooting Steps no sync signal jrc radar

In a marine radar system, the rotating antenna (scanner) and the display processor must be perfectly synchronized. Every time the antenna passes a specific point (usually the bow or an index line), a timing pulse is generated. This is the (also known as trigger pulse or heading pulse). | Step | Action | What to look